How to Clean Your Apple Watch in 5 Steps

Apple Watch with cleaning supplies

Maria Diaz/ZDNET

Remember that day when you would get stuck under your Casio calculator watch because you wouldn’t get the dirt off it?

You’d think we’d be safe from that Apple WatchBecause we have to constantly remove it Charge itBut you could be wrong.

Dirt, dust, dead skin and sweat are all still hidden in the crevices of your watch and can interfere with your watch. Apple Watch performance.

A Apple Watch Excess debris can collect around the digital crown, for example, causing it to become stuck. Just like on your iPhone, the speaker ports on your Apple Watch are another common victim of dirt, and removing them can help you The speaker volume is suddenly very low.

Further: I put the Apple Watch Ultra through a tough middle

How to Clean Your Apple Watch in 5 Steps

requirements

Start by removing the band from your Apple Watch; Let’s clean it separately.

To remove the band, place the watch on a flat, clean surface. Press the band release buttons. These are the two buttons in the middle where the band meets the watch.

While pressing the release buttons, slide the strap out of place and remove it completely.

Below are the buttons to press while sliding the watchband.

Hands removing the band on the Apple Watch

Maria Diaz/ZDNET
Buttons featured on the back of the Apple Watch

While pressing these buttons, slide the band out.

Maria Diaz/ZDNET

Further: Best Apple Watch Series 8 Bands

Inspect your Apple Watch closely and check for dirt in all hard-to-reach areas. Look carefully in the speaker ports, around the button and digital crown, and in the band slot.

Try removing any dirt stuck in the crevices of your watch with a cotton swab. If dirt won’t budge, hold your watch under gently running water to loosen it (see Apple support page Check how water-resistant your particular Apple Watch model is and never use soapy water. Then give it another shot with a cotton swab.

If you think you can be more gentle, you can try This time On the digital crown and speaker port (shown in the photo below). Using a Toothbrush Cleaning small crevices in your electronics is a great idea, if you are very careful. Use only the sides of the brush, not the tip. As much as you may want to, don’t use compressed air to clean your Apple Watch.

Using a Q-tip to clean an Apple Watch

Maria Diaz/ZDNET
Cleaning the speaker port with a brush

Only use the sides of the toothbrush, do not use the sharp tip.

Maria Diaz/ZDNET

Further: Apple Watch Ultra Teardown: Bigger battery, but harder to repair

Dip one of two cleaning cloths in clean water and wipe your Apple Watch, front and back. Make sure your cloth is damp, but squeeze out excess water before applying it to your watch. Notice the dirt you loosened with the brush and sweep it away.

Again, it’s important not to use soaps or detergents when cleaning your Apple Watch, and don’t submerge your watch in water, especially older models.

Cleaning the Apple Watch with a damp microfiber cloth

Maria Diaz/ZDNET

Unless you have a leather band, you can wipe your Apple Watch band with the same damp cloth or wash the band with a mild hand soap. Apple does not recommend cleaning its watchbands with abrasive soaps or cleaning agents.

Whether you clean your band or not, it will fade or change color over time and repeated use. Using detergents other than mild hand soap will increase fading and discoloration, so again, avoid them.

Cleaning Apple Watch bands with a damp cloth

Since my band wasn’t too dirty, I chose to wipe it off.

Maria Diaz/ZDNET

Use a dry, lint-free cloth to dry clean parts of your watch. Before putting your band back on your Apple Watch, make sure every part of your watch and band is completely dry.

To reassemble your Apple Watch, place it face down on a clean surface again, then grab the band with the letters and numbers facing you and slide each one into the slot until you hear a faint click.

Dry the Apple Watch and band pieces on a microfiber cloth

My watch after drying the individual pieces with a microfiber cloth.

Maria Diaz/ZDNET

Frequently Asked Questions

Can I sterilize my Apple Watch?

If you’ve owned an Apple Watch for the past few years, you’ve probably wondered if it’s safe to sterilize your Apple Watch without damaging it. Apple approves the use of certain disinfectants to safely clean your watch:

  • 70% isopropyl alcohol wipe
  • 75% isopropyl alcohol wipe
  • Clorox Disinfectant Wipes

This obviously doesn’t mean you can scrub your Apple Watch with a Clorox wipe, but you can gently wipe the outside of the Apple Watch and the band with one of these wipes, avoiding the leather and fabric bands.

How to clean a smelly Apple Watch band?

The Sport Band on the Apple Watch unfortunately often stinks, especially when worn during exercise. A good way to get rid of this smell is to remove it from the watch, wash it thoroughly with hand soap, dry it with a microfiber towel, and make sure it is completely dry before wearing it again.

If the smell persists, wipe with an isopropyl alcohol wipe, especially the underside, and allow to air dry completely.

Further: The new Apple Watch Ultra bands work with other Apple models

Can I wash my Apple Watch in the sink?

Apple doesn’t recommend washing its smartwatches with soap, as soap residue can get stuck in small parts of the watch and cause problems. This doesn’t mean you can’t shower with your watch or do dishes with it, depending on the model. Again, check Degree of water resistance A model that belongs to you.

However, if it’s not leather, you can wash the pants in the sink with mild hand soap.

I don’t wash my Apple Watch in the sink, but every night before bed, I take it out and wipe it down with a Clorox wipe, then let it air dry thoroughly before charging it or wearing it again.

Can I clean the Apple Watch leather band?

Leather straps are not waterproof and may become discolored if improperly cleaned. If your Apple Watch has a leather band and needs cleaning, you can clean it with a slightly damp cloth, taking care not to wet the leather. Allow it to air dry before wearing again, but don’t expose it to the sun to do so, as it will damage it. Simply air dry your leather strap.

What to avoid when cleaning Apple Watch?

  • Avoid any harsh cleaners and products containing bleach or hydrogen peroxide.
  • Do not submerge your Apple Watch in cleaning solutions or soapy water. Do not submerge older models in water.
  • Do not use compressed air or ultrasonic cleaning.
  • Do not blow dry your Apple Watch or leave it in the sun.
  • Never polish or buff your Apple Watch.

Source link

Denial of responsibility! newsnaveen.online is an automatic aggregator around the global media. All the content are available free on Internet. We have just arranged it in one platform for educational purpose only. In each content, the hyperlink to the primary source is specified. All trademarks belong to their rightful owners, all materials to their authors. If you are the owner of the content and do not want us to publish your materials on our website, please contact us by email – admin@newsnaveen.com. The content will be deleted within 24 hours.

Similar Articles

Popular post